Zipper Enclosure Kits

Note: Zipper extrusion is noted as TOPS and BOTTOMS. Zipper extrusion itself is different than windshield extrusion by the fact that it has a “C” channel that runs the full length of the pieces so that the bead from the enclosure will fit into it. The BOTTOM is different than the top because it has also has to hold the windshield on the car.

One Piece Windshield: One piece windshields require 4 bottom pieces of the zipper extrusion.

All Zipper Enclosures include the following parts:

Part Number – 5166
(2) Rubber windshield clips – used to keep the windshield in the up position

Part Number – 5224
(4) Black screws – These are used to fasten the Rubber windshield clips to the golf cart frame.

Club Car Windshields Pre 2000

Part Number – 5152
(2) 18” Pieces of Black Zipper Extrusion – Tops

Part Number – 5154
(2) 12” Pieces of Black Zipper Extrusion – Bottoms – These pieces have holes drilled in them at the center. This is so the bottom of the windshield frame will work with the extrusion.

Club Car Windshields 2000

Part Number – 5152
(2) 18” Pieces of Black Zipper Extrusion – Tops

Part Number – 5154
(2) 12” Pieces of Black Zipper Extrusion – Bottoms – These pieces have holes drilled in them at the center. This is so the bottom of the windshield frame will work with the extrusion.

E-Z-GO Marathon Windshields

E-Z-GO TXT Windshields

Part Number – 5164
(2) 20” Pieces of Black Zipper Extrusion – Tops

Part Number – 5170
(2) 12” Pieces of Black Zipper Extrusion – Bottoms

Yamaha Windshields

Part Number – 5152
(2) 18” Pieces of Black Zipper Extrusion – Tops

Part Number – 5154
(2) 12” Pieces of Black Zipper Extrusion – Bottoms